Volume 3, Issue 4 (Winter 2017)                   johe 2017, 3(4): 61-67 | Back to browse issues page

XML Persian Abstract Print

Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:

Nakhaei pour M, Shojaee farah abadi H, Najarian F, Safinejad M, Irvani H. Determining the efficiency of ZSM-5 zeolite impregnated with nanoparticles of titanium dioxide in the photocatalytic removal of styrene vapors. johe. 2017; 3 (4) :61-67
URL: http://johe.umsha.ac.ir/article-1-236-en.html
, irvanih91@gmail.com
Abstract:   (4762 Views)

Introduction: Styrene monomer is a volatile organic compound that has many applications particularly in plastic, rubber and paint industries. According to the harmful effects of these compounds on human and environment, reducing and controling of them seem necessary. Therefore, in this study removal of styrene was investigated using photocatalytic process of titanium dioxide nanoparticles stabilized on ZSM-5.

Methods: After stabilization of titanium dioxide nanoparticles on ZSM-5 zeolite, BET, SEM and XRD analysis were used to determine the characteristics of nanoparticles. Experiments were conducted at ambient temperature in laboratory scale. Concentration of produced styrene in the experiments was 50 and 300 ppm, and input flow rate was 1 l/min.

Results: images and spectra obtained through XRD and SEM-EDAX showed that  nano-catalysts are well- stabilized. The results showed that by increasing of input concentration of styrene from 50 to 300 ppm, photocatalytic removal efficiency are reduced. Also, adsorption capacity of the catalyst bed in concentrations of 50 and 300 ppm was calculated 16.3 and19.4 mg/gr of adsorbent respectively.

Conclusion: The results show that the use of hybrid bed can increase the removal efficiency of contaminants. And due to low cost of application of these systems compared to conventional methods, it is recommended that more comprehensive studies to be done regarding the optimization of the parameters affecting the process of photocatalytic removal.

Full-Text [PDF 859 kb]   (2893 Downloads)    
Type of Study: Research Article | Subject: Chemical agents

1. Yu W, Deng L, Yuan P, Liu D, Yuan W, Liu P, et al. Surface silylation of natural mesoporous/macroporous diatomite for adsorption of benzene. Journal of colloid and interface science. 2015;448:545-52. [DOI:10.1016/j.jcis.2015.02.067] [PMID]
2. Lim M, Zhou Y, Wood B, Guo Y, Wang L, Rudolph V, et al. Fluorine and carbon codoped macroporous titania microspheres: highly effective photocatalyst for the destruction of airborne styrene under visible light. The Journal of Physical Chemistry C. 2008;112(49):19655-61. [DOI:10.1021/jp807983a]
3. Thiruvenkatachari R, Vigneswaran S, Moon IS. A review on UV/TiO2 photocatalytic oxidation process (Journal Review). Korean Journal of Chemical Engineering. 2008;25(1):64-72. [DOI:10.1007/s11814-008-0011-8]
4. Rismanchian M, Akbari J, Keshavarzi R. Removal of gaseous toluene by using of the photocatalytic activity of TiO2 coated on foam nickel metal. 2014. 2014:10.
5. Mumpton F, editor Using zeolites in agriculture in innovative biological technologies for lesser developed countries. Workshop Proceedings, Washington DC; 1985.
6. Kazemian H. [Introduction to Zeolites, Misterious Minerals (Persian)]. Tehran: Zali Press. 2006:124-8.
7. CARBON XYSIOA, THROUGH HYDROGEN SULFIDE OXIDATION [dissertation]. Faculty of Engineering : University of Pittsburgh p-.
8. Sharifi Z, Aghabeigi S. Preparation and characterization of nano tin dioxide and Photo-catalytic properties of Congo red dye degradation. NCWNN1394; Tehran: Nqano-technology Commitee of Iran; 2015. p. 1-5. [PMID] [PMCID]
9. Adamson A. Gast.; AP Physical chemistry of surfaces. Wiley: New York; 1997.
10. Säämänen A. Methods to control styrene exposure in the reinforced plastics industry: Technical Research Centre of Finland; 1998. [PMID]
11. EPA. Drinking Water Standards Technical Factsheet on: Styrene. Water. 1993. p. 1-4.
12. Chen J-C, Tang C-T. Preparation and application of granular ZnO/Al 2 O 3 catalyst for the removal of hazardous trichloroethylene. Journal of hazardous materials. 2007;142(1):88-96. [DOI:10.1016/j.jhazmat.2006.07.061] [PMID]
13. Rostami R, Jonidi Jafari A, Rezaee Kalantari R, Gholami M. Survey of modified clinoptilolite zeolite and cooper oxide nanoparticles-containing modified clinoptilolite efficiency for polluted air BTX removal. Iranian Journal of Health and Environment. 2012;5(1):1-8.
14. Dezhi S, Sheng C, Chung JS, Xiaodong D, Zhibin Z. Photocatalytic Degradation of Toluene Using a Novel Flow Reactor with Fe‐doped TiO2 Catalyst on Porous Nickel Sheets. Photochemistry and photobiology. 2005;81(2):352-7. https://doi.org/10.1111/j.1751-1097.2005.tb00194.x [DOI:10.1562/2004-06-19-RA-207.1] [PMID]
15. Khatamian M, Alaji Z. Efficient adsorption-photodegradation of 4-nitrophenol in aqueous solution by using ZnO/HZSM-5 nanocomposites. Desalination. 2012;286:248-53. [DOI:10.1016/j.desal.2011.11.031]
16. Friesen DA, Morello L, Headley JV, Langford CH. Factors influencing relative efficiency in photo-oxidations of organic molecules by Cs 3 PW 12 O 40 and TiO 2 colloidal photocatalysts. Journal of Photochemistry and Photobiology A: Chemistry. 2000;133(3):213-20. [DOI:10.1016/S1010-6030(00)00237-9]
17. Takeuchi M, Hidaka M, Anpo M. Efficient removal of toluene and benzene in gas phase by the TiO 2/Y-zeolite hybrid photocatalyst. Journal of hazardous materials. 2012;237:133-9. [DOI:10.1016/j.jhazmat.2012.08.011] [PMID]
18. Rangkooy H-A, Rezaee A, Khavanin A, Jafari AJ, Khoopaie A-R. A Study on Photocatalytic Removal of Formaldehyde from Air Using ZnO Nanoparticles Immobilized on Bone Char. Qom University of Medical Sciences Journal. 2011;7(2).
19. Moussavi G, Rashidi R, Khavanin A. The efficacy of GAC/MgO composite for destructive adsorption of benzene from waste air stream. Chemical Engineering Journal. 2013;228:741-7. [DOI:10.1016/j.cej.2013.05.032]

Add your comments about this article : Your username or Email:

Send email to the article author

© 2020 All Rights Reserved | Journal of Occupational Hygiene Engineering

Designed & Developed by : Yektaweb